S0001498 - Hub and Bearing Puller hydraulic trolley Elvis Lightning

!! ATTENTION !!
Transport trolley allowed only after closing the drawers with the key.

Service hub / bearing press

Disassembly and assembly of the hub / bearing takes place on the vehicle without removing the ABS sensor

The product is packed in a metal trolley on wheels, equipped with 6 drawers.
Drawers equipped with locks preventing pulling out several drawers at the same time.
Drawer inserts made of foam.
Each tool has an assigned place in the drawer.
Thanks to such a solution, there is a good order in the workplace.

Application:
- Mercedes Sprinter
- Mercedes Vito
- Mercedes Viano
- Volkswagen Crafter
- Ford Mondeo, Focus
- VW T5 T6 - front and rear axle
- VW Polo, Skoda Fabia, Seat Ibiza - also Fabia front axle after modification of the steering knuckle
- Mazda 3
- Volvo C30 / C70 / S40 / V50

Set contains:
1 - M Adapter for pressing the hub - Mondeo bearings
2 - M Adapter for ironing bearings - Mondeo hubs
3 - F Adapter for ironing bearings - Focus hubs
4 - F Adapter for turning the hub - Focus bearings
5 - Instrument stand
6 - Hydraulic pump
7 - Hydraulic cylinder
8 - Adapter for ironing bearings - Focus Mondeo hubs
9 - Hub insertion adapter - Focus, Mondeo bearings
10 - Puller screw
11 - Nut puller nut
12 - Ford tripod distance plate
13 - Adapter for ironing the bearing hubs VW, T5, T6
14 - Hub press adapter - VW, Seat, Skoda bearings
15 - Hub press fitting adapter - bearings (VW, Seat, Skoda and VW T5 T6 bearing pressings)
16 - Center ring for pressing the hub - Volkswagen bearings
17 - Spacer to press the hub - Volkswagen bearings
18 - Volkswagen tripod distance pin
19 - Hub pressing ring - Volkswagen bearings
20 - Cross-over distance ring after Volkswagen modification
21 - Spacer ring for replacing hubs
22 - A set of rings for ironing double row bearings on the front and rear axles
23 - Hub hub puller / bearings main plate
24 - Hub puller / bearing
25 - Hub / bearing insertion adapter
26 - Tripod distance screws
27 - Spacers of the tripod
28 - Tripod tripod screw
29 - Correction nut
30 - Motherboard stamps
31 - Main board connector stamp
32 - Main board connector screw
33 - Main board punch connector
34 - Centering screws for the actuator
35 - Main board connector
36 - Yoke stabilizer
37 - Puller washers
38 - Yoke stabilizing plate for Mercedes Vito, Viano - Left side
39 - Yoke stabilizing plate for Mercedes Vito, Viano - Right side
40 - Adapter for ironing the rear swingarm bearing on a Mercedes Viano, Vito 2,2 CDI W639 after 2003
41 - Adapter for ironing the rear swing hub in a Mercedes Viano, Vito 2,2 CDI W639 after 2003
42 - Adapter for ironing the rear swingarm bearing on a Mercedes Viano, Vito 2,2 CDI W639 after 2003
43 - Adapter for ironing the bearing and pressing the rear wishbone hub on a Mercedes Viano, Vito 2,2 CDI W639 after 2003